with terabytes of data, some of it worth quite a bit from a personal perspective (home video, photos and so forth) it's not practical to back this sort of volume up First, take the drive offline by issuing a 'remove' command. Verify = Compare of Mirror Sides RAID 5 and 50. Assuming that's not enough, the best approach at this point is to copy off the data from the array (or restore from backups). Source
maybe not? If you have any failure other than a failure of a single disk, you will have to recover from a backup. –David Schwartz Feb 10 '14 at 14:09 add a comment| This removes the failed drive from the array (unit). //server1/c4> /c6/p5 remove quiet You can now pull the drive physically out (you've got them all in hotswap caddies, You should be able to find support in Russia for your WD hard drive here: support.wdc.com/index.asp?lang=ru Sorry I wasn't able to get a more precise link -- Мой русский разбит! –Alexander http://serverfault.com/questions/574428/issue-rebuilding-raid5-with-3ware-controller
If the voltage is too high to operate, this AEN will be posted to the user. If the board itself nor any of the ICs seem scorched, and the drive is not reporting overtemperature from its SMART log, there should be no issue with the warranty. Login Username Password Forgotten your password?Request a new one here. 3ware, tw_cli command line and failed disks There's a reason I went for a proper 3ware RAID card... One side of the mirror does not equal the other side.
If the 3ware RAID controller detects this condition, it notifies the user, prior to entering the recovery phase, by displaying this AEN. When this error occurs, the unit will go back to degraded mode if possible. 00Fh SMART threshold exceeded The 3ware RAID controller supports SMART Monitoring, whereby the individual drives automatically monitor The controller may degrade the unit (if possible). 03Bh Rebuild paused This AEN will be sent when the rebuild operation is paused. Tw_cli Start Rebuild The user should replace the bad drive as soon as possible and initiate a rebuild.
Join them; it only takes a minute: Sign up Here's how it works: Anybody can ask a question Anybody can answer The best answers are voted up and rise to the Tw_cli U? One such possible failure of a disk drive is a failure of a command that is pending from the 3ware RAID controller to complete within a reasonable amount of time. The harddrive was used for 2 years in RAID with rather big load. http://www.brumster.com/articles.php?article_id=8 By Russ Foster in forum Dedicated Server Replies: 2 Last Post: 10-20-2004, 02:08 AM Verify Server Hardware By Prince in forum Dedicated Server Replies: 5 Last Post: 01-07-2004, 10:02 PM User
Complete message: Available Drives (Controller ID 0) Port 1 WDC WD1000FYPS-01ZKB0 0.00 MB NOT SUPPORTED [Remove Drive] SMART gives me only Device Model and ATA protocol version 1 (not 7-8 as http://www.webhostingtalk.com/showthread.php?t=1128035 By registering you'll gain: - Full Posting Privileges. - Access to Private Messaging. - Optional Email Notification. - Ability to Fully Participate. - And Much More. 3ware Ecc Error However, if you are lucky, that sector might not actually be used by the filesystem located on that volume, therefore you might still be able to copy your data from the 3ware Degraded Drive Verify = Compare of Parity Data with User Data When the verification starts, this AEN is posted to the user. 02Ah Verify failed This AEN indicates that the data integrity verification
Now the raid array is INOPERABLE. … 3Ware 9650SE RAID-6, two degraded drives, one ECC, rebuild stuck. 0 3ware raid controller, unit unusable, several degraded disks. this contact form It stays at 97% rebuilt, but can't get past this error. As part of power-on initialization, the 3ware RAID controller performs a checksum of the DCB area to ensure consistency. This AEN is posted when the result of the health test is below the warning threshold. Ecc Error 3ware Raid
The vibration issue is interesting, will look into this. The user must replace the battery pack if the temperature error persists. Results 1 to 7 of 7 Thread: 3Ware Hardware RAID - Auto Verify ON or OFF Tweet Thread Tools Show Printable Version Subscribe to this Thread… Search Thread Advanced Search http://theblackinkproject.com/ecc-error/3ware-error.html Regards, Suhail.
thus... Hard Drive Ecc Error Reply With Quote 0 02-20-2012,04:24 AM #7 barbus View Profile View Forum Posts View Forum Threads Visit Homepage Aspiring Evangelist Join Date Aug 2010 Location Prague, Czech Republic Posts If the capacity of the migrated array is larger, please refer to the part of this document on migration for information on how to change the file system to use the
Possible causes of APORT time-outs include a bad or intermittent disk drive, power cable or interface cable. 00Ah Drive error detected As part of the recovery mechanism of the 3ware RAID If a valid DCB is found, the primary DCB is re-written to rectify the errors found. 043h Backup DCB read error detected This AEN will be sent when the controller sees This AEN is posted when cache synchronization was not successful for some reason. 3ware Degraded Ecc-error Countries where lecture duration does not exceed one hour What are the best old electrical appliances to extract electronic components from?
Done. //server1/c6> showUnit UnitType Status %RCmpl %V/I/M Stripe Size(GB) Cache AVrfy------------------------------------------------------------------------------u0 RAID-5 REBUILDING 0% - 256K 3725.25 ON OFF... Are there eighteen or twenty bars in my castle? I'll speculate that the guy who set this up turned that off for performance reasons :( –Bill Weiss Nov 24 '11 at 3:41 Well, that got it through the Check This Out If the co-signer on my car loan dies, can the family take the car from me like they're threatening to?